11
GETTING STARTED
SAFETY / SPECIFICATIONS
ASSEMBLY / INSTALLATION
OPERATION
TROUBLESHOOTING
MAINTENANCE / REPAIR
22. Shows Manual or Auto Mode
23. Touch to clear all set data (back) to zero setting.
Choose Yes or No from the
following dialogue box
24. Touch to show the next job screen. This button shows
“Home” at the end of the cutting jobs. Touching it will take
you back to the Main (Home) F1 screen.
To cancel a job touch the execution number.
25. Clear Settings for each operation.
Press any CLR button for two seconds to clear length
and quantity parameters. The settings will revert to
zeroes.
26. Finished Quantity - refers to the number of cut pieces
completed.
37. Quantity Setting - Set the cutting quantity procedure as
same as the cutting length setting. There are 10 total job
slots available for altering the production quantities.
28 . Length Setting - refers to the length of cut pieces.
Interface Control Screen - Language Settings - F4
The F4 button for will display the screen shown above. Choose
one of the languages and press the Back to front page to return
to the Main (Home) Screen.
OPERATION - MACHINE ERROR
NOTIFICATIONS
The Interface Control Screen will show error notices when
machine malfunctions occur. The screen will display the probable
cause and possible remedies. A listing of errors and remedies
can be on page 19 in the Troubleshooting section.
OPERATION - SAW BLADE INSTALLATION
AND GUIDE ADJUSTMENT
Always disconnect the machine from its
power source before changing blades or
carrying out any maintenance procedure even in the case of
irregular machine operation.
Choose a proper saw blade best suited for the workpiece to
be cut. The size and shape of the workpiece plus the type of
material should all be considered when selecting an appropriate
saw blade.
Removing and installing the blade
1. Raise the saw bow to a height clearing the bench vise
jaw, use switch “F” (pg. 6).
2. Disconnect the machine from the power source.
3. Open wheel cover (1B) and clean the chips out of the
machine.
2B
4. Loosen the adjusting screws (2B) to loosen the carbide
guides from the guide blocks.
5. Slide the left blade guide post to the right as far as
possible.
3B
6. Release the blade tension by turning the blade tension
lever to the “Loosen” position (3B)
4B
7. Unlock the chip brush handle (4B) then push the chip
brush assembly down.
