paladin HARLEY POWER BOX RAKE T6, Руководство оператора и каталог запасных частей

Страница: 13 / 50

2
MODEL T6 HARLEY POWER BOX RAKE®
OPERATIONAL PROCEDURE
NOTICE
The T6 Power Box Rake® is designed for removing rock and small debris,
and for thatching. This manual contains information for the T6 models. Refer
to the information in this manual for specifications, parts, assemblies, and
adjustments.
ATTACHING POWER RAKE TO TRACTOR
Move tractor into position in front of the power rake. Move back slowly and carefully, not allowing
anyone to be between the tractor and the rake. Turn off tractor engine. Attach the two lower
arms of the 3-point hitch with the two hitch-pin assemblies.
Attach the tractor center link to the upper hitch point of the power rake. Use either the “lock-out”
setting or the “float” feature depending on your application.
Attach the front PTO from the power rake to the tractor. Slide the front section of the PTO into
the back section and attach to the PTO shaft at the rear of the tractor.
Reattach driveline storage chain in its original position so that it will contact PTO driveline.
If the PTO is too long, severe PTO and gearbox damage is possible
when hooking up the PTO from the power rake to the tractor. The front
PTO is long enough to fit a variety of tractors. It is possible that the
front PTO will need to be cut. There will be NO benefit by cutting only
one telescoping section. Both sections of the PTO must be cut. DO
NOT FORCE THE PTO TO FIT.
WARRANTY IS VOID IF THE PTO IS TOO LONG, resulting in gearbox,
PTO, yoke, or cross bearing damage.
The PTO, when attached to the tractor and gearbox, must not extend so there is less than five
inches of overlap within the PTO.
Attach the two hydraulic lines on the rake to the two female hydraulic couplers on the tractor.
The hydraulic hose ends on the power rake are ISO male couplers, which are compatible with
newer tractors.
Raise jackstand and secure in operating position.
Always clean connector ends prior to attaching. Dirt could contaminate
hydraulic fluid and damage the hydraulic system.