paladin HARLEY POWER BOX RAKE T6, Руководство оператора и каталог запасных частей

Страница: 22 / 50

MODEL T6 HARLEY POWER BOX RAKE®
2
MAINTENANCE
TOP BEARING HOUSING SERVICE
If it is necessary to service the bearing housing because of bearing or shaft failure, please fol-
low these instructions. See Figure 10 (page 44) .
We suggest the bearings also be replaced when the shaft is replaced.
Removal
. Remove chain from top sprocket, cotter pin, slotted nut, and washer.
2. Remove the clutch shield and side PTO.
3. Remove the four bolts holding the bearing housing to the chain case.
4. Press on end of shaft with dimple hole, forcing the shaft to come out. It will now be neces-
sary to reach with a large punch and push each bearing out.
Reassembly
. Press bearing in bearing holder with collar of bearing to the center of the holder. Be careful
to press only on the outer bearing race until the bearing hits the shoulder and stops. See
Figure 10 (page 44) .
2. Insert the shaft in the bearing with the spline end at the flange end of the holder.
3. Slide the sleeve over the shaft and into the bearing holder.
4. Press bearing into the bearing holder with the collar part of the bearing facing toward the
center of the holder. Be careful to press on both the outer and inner bearing race rests on
the sleeve. See Figure 10 (page 44) .
5. Replace O-ring and O-ring space. Check O-ring for cuts or nicks.
6. Apply a liberal amount of silicone sealer to the inside of the flange. Attach the bearing
holder to the chain case with four bolts and lock washers.
7. Slide the top sprocket, hub first on the shaft. Use machine bushings on the inside or out-
side of the sprocket for proper alignment.
At least one machine bushing MUST be placed between the sprocket
and the bearing to prevent damage to the bearing.
8. Replace washers, slotted hex nut, and cotter pin. Replace chain, PTO, and clutch guard.
BEARING & ROLLER REPLACEMENT
Left Roller Bearing
. Remove drive chain. Then remove lower sprocket by removing cotter pin, slotted hex nut,
and washer.
2. Remove the two bolts holding the chain case to the frame.
Have roller blocked up or supported and slide chain case and bearing
off roller shaft.
The top drive shaft will come off with the chain case.
3. Loosen bolt on the bearing tube that holds cartridge bearing in place. Remove bearing and
O-ring.
NOTICE
NOTICE
NOTICE