ZENIT
80
+
TYPE TUBE RADIANT HEATER
Instructions for Installation and Servicing
9
7. Place all reflectors at their positions and join them with a minimum 50 mm overlap.The joining with one another will be explaned
on the next pages!
8. Then connect burner into the burner tube, depending on execution.
Not expanded tubes with clamp-connection : The clamp is premounted on the burner tube on its corresponding position at the factory.
The burner must be connected to the free end of the clamp, where the unexpanded tube part must be inserted untill the bumper screw.
After finishing the inserting process the screws must be tighten.
I-form combi hanger
„U” - form combi hanger
6.picture: Reflector hanger
6. After the assembly of tubes, place combination hangers and reflector hangers at their position. Do not deviate from recommended
positions by more than ±100mm the mounting of the hangers.
7.picture: Clamp connection
Burner tube
Metalsheet screw (fixing)
PROPER
IMPROPER
Metalsheet screw (bumper)
Burner
Metalsheet screw
Burner
