ZENIT
80
+
TYPE TUBE RADIANT HEATER
Instructions for Installation and Servicing
6
•
Never use the unit to support other equipment.
•
Never leave tools, spare parts, etc. inside the unit.
•
Make sure that all inspection panels are closed properly.
•
Do no expose the unit to inflammable gases.
•
In case of breakdown or failure: turn unit off, do not try to repair it on your own, call operator.
•
If you are going to leave the heater switched off for a long time, first make sure that in no way this could cause harm
to anyone in any way.
•
The delivery must be made according to the following:
→
The package must be carefully secured in the loading space.
→
The package must be transferred in a closed space (always keep packing parts away environmental impacts).
•
The unit has a special safety packing for transport and delivery which must be kept in good conditions till the unit is positioned
on the installation place.
•
Make sure that the unit has all its parts, as specified in the order.
•
Check if there are any damages and if the unit abbreviation is the same as the one of the ordered model.
•
Every unit is factory tested before shipment, therefore, if there are damages, report them immediately to the carrier.
Transporting, unloading and moving is a process which must be made carefully to avoid any kind of damages. Try not to use the unit’s
components as hand holds. When lifting, bear in mind that the centre of gravity of the unit may be off-centre.
CAUTION
!
DANGER
!
ATTENTION
!
THE USIGE OF
MOVING EQUIPMENT
IS COMPULSORY
ATTENTION
!
FORBIDDEN!
ATTENTION
!
ONLY
QUALIFIED
PERSON
The appliances will be delivered in card board box. The unpacking process of the appliance:
•
unload the burner the tubes and the accesories from the card board box.
•
do not remove the protection cap from the burners gas connection or from the gas joining set (optional) util You do not
conect it to the pipe line.
•
Check the unit and its accesories for any damages which could be arise during the transportation.
•
if there are any damages found, report them immediately to the manufacturer or your closest dealer.
There is an envelope inside the unit containing the Instructions for Installation and Servicing, User’s Guide use and Guarantee and
services and the warranty documents.
3.
Transportation, unpacking, handling
ATTENTION
!
FORBIDDEN!
ATTENTION
!
ONLY
QUALIFIED
PERSON
4.
Operation principle
The appliance operates on the basis of radiant heating. The combustion products of burned up gas and air mixture flow through the thin-
walled browned straight or „U”-form pipes and warm it up. The aluminium reflektor shields, which have the best reflecting ability radiant
the made heat to the heated area.
Operation principle:
the centrifugal fan of tube radiant heater draws in the combustion-air and pushes out the combustion products -
made by burning up of gas and air mixture at the „pusher” side of fan in the burner head – through the flue system into the open air.
The variety-list of appliances to be found in the
enclosure 1.
The heating and consumption values to be found in the
enclosure 2.
as per appliance and gas types.
The supply of combustion air of appliance can be realized in two ways:
• directly from the heated place
• from open air trough air duct, it can be used in case of such plants, which are working with dangeros materials as follows:
painting workshops and workshops, which are using explosive or corrosive materials etc.
