Painless Performance Products 90542, Руководство по установке

Страница: 18 / 24

Figure 8-7B Separate Turn/Brake Lights
8.10 Helpful Hints for Tail Section Wiring
8.10.1 When you have Integrated Brake Lights on your vehicle the Turn Signal switch acts as a brain to
control when the Lights in the rear are on constantly (braking) or flashing (turning) or a
combination of both. The Turn Signal switch you use must be built to do this! If you are
using a steering column out of a salvage yard that was originally in a vehicle that had
separate Brake Lights then the switch will not work for Integrated Brake Lights.
8.10.2 Almost all light bulbs get the ground they need through the socket housing. If you mount your
socket housing into anything other than a grounded metal part then you will need to provide a
separate ground wire.
8.10.3 This kit has a bag containing 30 Mopar lamp socket terminals. These terminals fit all lamp socket
housings through out the entire vehicle. Follow these instructions for proper installation and refer
to
Figure 8.10B
:
1: Insert the wire into the correct location of the lamp housing.
Housing must be installed before
the terminal is crimped. These terminals are pull to seat.
2: Slide the factory spring over the wire. You must re-use your factory spring.
3: Place the terminal over the wire by prying up the center “prong” and sliding the wire under,
see the arrow in Figure 8.10A
, then crimp. If the wire is not inserted under the prong,
a proper crimp will be impossible to achieve.
Figure 8.10A Lamp Socket Terminal
Figure 8.10B Lamp Socket Assembly
18