2. Insert two (2) bearings and a bearing spacer into a
gear with the spacer between the bearings. Place a
thrust washer on each side of the gear and position
in a carrier opening. Slide the shaft through the car-
rier, thrust washer, bearing-gear sub-assembly and
remaining thrust washer.
3. Carefully align the pin hole in the carrier with the
hole in the planet gear shaft and drive the roll pin
into place. Always use NEW roll pins. When prop-
erly positioned, 50% of the roll pin will engage the
planet gear shaft and 50% will remain in the planet
carrier.
4. Note that the roll pin is slightly recessed in the car-
rier when properly installed. With a center punch,
stake the carrier next to the pin hole as shown. This
will distort the hole so the pin will not back out.
Repeat these steps for each of the three planet
gears.
PRIMARY PLANET CARRIER
1. To service the primary planet carrier, the steps are
the same as for the output carrier except there is
only one bearing for each gear and no bearing spac-
er.
18
Содержание BRADEN H20R
Страница 27: ...26 BRADEN H20R 05559 COMPONENTS ...