Paccar Winch BRADEN Gearmatic BG6A, Инструкция по установке, обслуживанию и ремонту

Страница: 28 / 35

1. Place hoist base on side with bearing support end up.
2. Install a new bearing in the drum if replacement is
necessary. Apply a non-hardening sealant on the out-
side diameter of the new seal. Install the spring side
of the seal next to the bearing, then press into the
drum, using a flat plate to avoid distortion. Be sure
drain plug is installed securely.
3. Center the drum in the opening of the base. Lubricate
the bearing support with petroleum jelly or gear oil
and install in base and drum.
4. Tighten the bearing support capscrews to the recom-
mended torque.
5. Stand hoist on bearing support end. Install the output
sun gear and thrust washer into output planet carrier.
26
HOIST ASSEMBLY
Make certain the snap ring is installed on the bearing
support. This snap ring will keep the output planet car-
rier correctly positioned in the hoist. Gear train damage
may occur if this snap ring is omitted.
CAUTION
Be sure the vent plug is located above the horizontal
centerline for the intended application. Oil leakage
may occur if vent is positioned incorrectly.
CAUTION