Paccar Winch BRADEN Gearmatic BG6A, Инструкция по установке, обслуживанию и ремонту

Страница: 27 / 35

2. Insert two (2) bearings and a bearing spacer into a
gear with the spacer between the bearings. Place a
thrust washer on each side of the gear and position in
a carrier opening. Slide the shaft through the carrier,
thrust washer, bearing-gear sub-assembly and
remaining thrust washer.
3. Carefully align the pin hole in the carrier with the hole
in the planet gear shaft and drive the roll pin into
place. Always use NEW roll pins. When properly posi-
tioned, 50% of the roll pin will engage the planet gear
shaft and 50% will remain in the planet carrier.
4. Note that the roll pin is slightly recessed in the carrier
when properly installed. With a center punch, stake
the carrier next to the pin hole as shown. This will dis-
tort the hole so the pin will not back out. Repeat these
steps for each of the three planet gears.
PRIMARY PLANET CARRIER
1. To service the primary planet carrier, the steps are the
same as for the output carrier except there is only one
bearing for each gear and no bearing spacer.
25