P3 International E9311, Руководство по эксплуатации

Страница: 23 / 48

11.1. Adding new sensors
You can add new sensors into the system at any time.
Note that the maximum number of radio sensors (incl. combined sensor)
is 9 and avoid duplicate addresses.
• New sensors are automatically logged on twice daily (at intervals of 12
hours) during the regular sensor search.
• You can also add new sensors by reinitializing the base station.
Note that the device is reset to the factory settings, any stored
data will be deleted!
11.2. Resetting to factory defaults
The factory defaults are as follows:
•
Display panel A: Pool sensor or other sensor with address 8
•
Display panel B: Indoor sensor
•
No alarm thresholds set
•
Comfort range on display panel A: 77˚F to 82.4˚F.
•
Audible warning disabled
- Open the battery compartment, remove the batteries and reinsert the
batteries with the correct polarity.
- This sets all user settings to the factory default.
- All stored MIN-/MAX data is deleted.
- The device boots as described in chapter 7.
11.3. Reception status indicator
- The antenna icon (see above) is displayed while reception of the
selected sensor is good.
- If the signal is interrupted for more than 40 minutes, the antenna icon
starts to flash. The last values to have been received are displayed.
- If reception is interrupted for more than 12 hours, the antenna icon
disappears and the associated value is displayed as ”- - .-”.
11. Miscellaneous functions and settings