Owandy Radiology i-max touch, Руководство по обслуживанию

Страница: 53 / 267

SERVICE MANUAL
Pre-installation
I-Max Touch 5-1
5. PRE-INSTALLATION
The instructions indicated in this and in the following chapter enable to
perform a correct installation in order to grant a regular operation of the
I-Max Touch.
The supplier can supply the assistance and the necessary technical
advice for pre-installation, all masonry works and the pre-installation
phase are at the customer’s charge and must be performed complying
with the indications given below.
The requirements for a correct installation of the I-Max Touch are:

minimum height of the room: 2.5 m (8.20 ft) and a surface variable
according to the configuration of the I-Max Touch to be installed, as
indicated in the picture at paragraph 5.3

a certain distance from heating devices

the entries in the room, for the transport of the unit, must have a
minimum width of 80 cm (31.50").
WARNING:
In its standard versions, the I-Max Touch must be fixed to the wall with
the two brackets supplied. Each dowel must support a max. extraction
force of 120 kg (264 lbs).
The fixing dowels to be employed, for any kind of wall, are the following:

full or concrete bricks: screw anchors (provided with the
installation kit) in cast-iron M6 or chemical screws WURTH (not
provided)

wood mountings: self-threading screws (not provided)

hollow bricks: chemical dowels (not provided).
A special floor mount option is available; in this case the equipment
MUST be fixed to the floor.
The manufacturer is not responsible for any installations that do not
comply with the specifications stated above.