Owandy Radiology i-max touch, Руководство по обслуживанию

Страница: 54 / 267

SERVICE MANUAL
Pre-installation
I-Max Touch 5-2
5.1. Electrical setting up

Single-phase grounding supply 220-240 V ~
110-120 V ~

Frequency 50/60 Hz

Power consumption 1.6 kVA (at 230 V)
1.7 kVA (at 115 V)

Current consumption 7 A (at 230 V)
15 A (at 115 V)

Apparent line resistance 0.5

max (for 220-240 V version)

Line voltage regulation < 3 % at 99 V ~
(for 110-120 V version)
NOTE:
The device is supplied as a unit to be installed permanently.
Please DO NOT connect the unit to the power using a normal socket, to
avoid compromising the electrical safety.
The unit must be connected to a differential magneto-thermal
switch, to separate the unit from the supply. This switch must
comply with the electrical regulations in force in the country of
installation.
The supply conductors must have a 1,5 mm
2
(16 AWG) section.
The general grounding must comply with the rules in force; a wrong
quality of the grounding could be dangerous for the operator’s safety and
cause a bad function of the electrical devices.
NOTE:
The I-Max Touch, IS SET TO connect, at the entrance of the X-ray room,
the following control and warning devices:

REMOTE X-RAYS BUTTON: "Dead man switch" remote control,
enables to perform the exam at a distance, the operator can stand
outside the X-ray emission area. This button must be suitable to
prevent unwanted emission. The standard X-ray button supplied with
the unit has the above characteristic.

READY light: Green light (24V 40W max.), it signals that the machine
is ready to perform the exam. (contact N.O.).

X-RAYS light: Yellow light (24V 40 W max.) it signals the entry in the
X-ray room is forbidden, since an exposure is on the run. (contact
N.O.).
WARNING:
It is installer’s responsibility to check the characteristics of the remote
X-ray button

