84
4.5.1 WIRELESS - Setup
The Setup configuration page describe the basic wireless setting for the WL-8064ARM Wireless ADSL2/2+
Router.
By default, any wireless PC that is configured with the correct SSID will be allowed access to your wireless
network.
Enable AP:
Place a check to Enable or Disable the built in Wireless Access Point built in the
WL-8064ARM Wireless ADSL2/2+ Router. The Wireless Access Point must be enabled to allow
wireless stations to access the Internet.
SSID:
The Service Set Identifier, also known as the Wireless Network name. The Service Set
Identifier ( SSID ) is a unique name for your wireless network. If you have other wireless access
points in your network, they must share the same SSID.
The default SSID is
TI-AR7WRD
, but it is strongly recommends that you change your network
Name to a different value for security purpose. The SSID can be up to 31 characters.
Hidden SSID:
Place a check to enable the hidden of your WL-8064ARM Wireless ADSL2/2+
Router SSID.
Channel B/G:
This field determines which operating frequency will be used. It should not be
necessary to change the wireless channel unless you notice interference problems with another
nearby access point.
802.11 Mode:
The default is
“Mixed”
, which allows both 802.11g and 802.11b wireless stations to
access this device.
“B only”
allows 802.11b wireless stations to be used,
“B+”
allows 802.11b+
wireless station to be used and
“G only”
allows only 802.11g wireless stations to be used to
access the WL-8064ARM Wireless ADSL2/2+ Router.
