Output Technology LaserMatrix LM2405, Руководство оператора

Страница: 52 / 249

2-20 Operations
EXTENDED CONFIGURATION MENU*
Reset Cnt= FusPd, Devlp. See Fuser Pad=... and Devlp. Ft=..., below
VCor.= 0.050 in, Page
*
Print Speed=
12ppm, 24ppm
*
Special Function=20 4, 0
*
Fuser Temp= 130C, 138C, 146C, 153C, 161C, 169C, 177C, 184C
Sleep Delay= 0 to 60 minutes in 1-minute increments with 6m
*
as default
APSense= Enable, Disable
*
Hex Dump= On, Off
*
Frm Width=21 3.5 to 8 in. in .125-in. increments (or 89 to 203 mm in 1-mm increments), Off
*
Form Cont= On, Off
*
PCL Frm Ctl= Off, On
*
Tot. Ft.=
nnnnnnnn feet, total feet of all media printed by printer engine. Not resetable.
Drum Feet= nnnnn feet, total feet of all media printed by present drum. Reset by changing drum.
EC FW Ver= nn-nn, present engine controller firmware version.
RIP FW Ver= nn-nn, present raster image processor firmware version.
Devlp. Ft= nnnnn, number of ft printed using the present developer. Can be reset by Reset Cnt=
Devlp.
Fuser Pad=
nnnnn, number of ft printed using the present fuser pad. Can be reset by Reset Cnt=
FusPd.
Scan Count=
nn scan lines detected per 1/6 in.
Diag Print= 0-3, print pattern
* Factory defaults are underlined. See Section 5, Extended Configuration Menu, for details.
20 Special Function Mode 4 prevents the printer from reversing direction on restart.
21 Option is displayed only if
PSize
stipulates a custom form length in the Configuration Menu. The type and range of
selections depends on the
In
or
Mm
setting in
Page Units=...
, also in the Configuration Menu.