OutBack Power HiQ TS208-5k75, Инструкция по установке и безопасности

Страница: 33 / 48

PRO208V-5k75 Installation and Safety Manual
900-0203-01-00 Rev B
33
The
DHCP
check box indicates current status. It also allows parameters
to be changed if DHCP is unchecked. When unchecked, the box looks like this:
Touching on one of the fields below the check box will activate it and allow changes to be made using the
on-screen keypad.
In general:

NET MASK
(network sub mask) remains at 255.255.255.0 unless being used in certain large companies
that might use something different.

GATEWAY
and
PRI DNS
(primary DNS) will be taken from the router screen.

SEC DNS
(secondary DNS) usually remains at 0.0.0.0.
Accessing the Gateway from Outside the Local Network – WAN-side configuration
In the example of the Cisco router, opening up a port for outside communication is achieved through the
Applications & Gaming
screen. (See Figure 35.) The intent is for communication to pass through the router,
although there will usually be some translation of port labels between what the Gateway expects and what is
presented to the outside world on the WAN side of the router.
There are 4 possible ports required to fully access the Gateway and inverters remotely. Access to the control
web page alone requires only the first of those listed in Table 5 to be set up.
Label Function External (Customer-
changeable as required) Internal (what the
Gateway expects to see)
HTTP Allows access to the Gateway web page 8100 80
FTPC FTP Control — allows access to the Gateway
memory card and logs 2100 21
FTPD FTP Data — the return port for files requested
using FTPC to be transmitted through 8000
(Use this setting only)
8000
Diag Diagnostic — Low level system access
such as firmware updates for use by the
manufacturer only 1000
(Use this setting only)
1000
Table 5: Port numbering assignments
Figure 34: Network Setting
screen on the Gateway