Otto Bock 490E75 1 C Series, Инструкция по эксплуатации

Страница: 53 / 128

LCD screen in "IR Menu" mode
Display Information
When "IR Menu" mode is selected, a list of the devices that can be operated using
environmental control is displayed.
A list of assigned control commands (IR codes) is stored for each device. Using the
example of a television set (TV), the following commands are available: [On], [Off],
[Volume up], [Volume down], [Mute], [HDMI].
When the selected command is issued using the respective installed input device,
the list entry is highlighted red.
7.6.4.6.2 Learning and assigning IR codes
Programming devices
The "IR Menu" mode is only available if commands for controlling devices (IR codes) have been saved in the
wheelchair control device. There are two methods for storing IR codes:
•
"Learning" the IR code with the help of the corresponding remote control (see below),
• Programming with the PC-based IR configurator (only by qualified personnel).
Learning prerequisites
To allow an optimal learning procedure the following recommendations should be followed:
•
Put new batteries in the remote control to ensure the IR signal is of good quality.
• Avoid directly exposing the IR sensor to daylight or lamps when signals are being transferred.
• Position the remote control directly in front of the control panel or the TEN° LCD module during the learning
process. When pressing a button on the remote control, make sure that the remote control remains still (do not
move it back and forth during learning). The ideal distance between the remote control and TEN° control panel
or TEN° LCD module is in the range of
40 to 100 mm
(1.57" to 3.94").
LCD screen in "Settings" menu
Display Information
TEN° control panel:
Open the "Settings" menu by pressing and holding the [Warn­
ing flashers on/off] button.
TEN° LCD module:
Open the "Settings" menu by pressing the [Settings] button.
Using the respective installed input device (e.g. joystick, up/down and right/left nav­
igation buttons on the TEN° LCD module, special control input devices), select the
menu item [IR Setup].
•
Scroll through the list: move forward/back
• Select entry: move to the right
Select a device, e.g. [TV]. The commands which have been set up for the device are
displayed.
53 490E75=1_C
Use