Otto Bock 3B5-X2, Инструкция по эксплуатации

Страница: 102 / 108

102
Status
LED Charging status
indicator (5 LEDs) Error Resolution
The LED
ring is
flashing
red The prosthesis is not
being charged
Defective battery
charger. Reset the error by dis­
connecting and con­
necting the power sup­
ply.
If the error persists, the
battery charger and
power supply must be
inspected by an
authorised Ottobock
Service Center.
17.2.3 Error messages while establishing a connection with the cockpit app
Error message Cause Correction
Component was con­
nected to another
device. Establish con­
nection?
The component was
connected to another
device To disconnect the original connection, tap
the "
OK
" button.
If the original connection is not to be dis­
connected, tap the "
Cancel
" button.
Mode change failed
An attempt was made to
switch to a different
MyMode while the com­
ponent was in motion
(e. g. while walking) For safety reasons, switching MyModes is
only permitted when components are at
rest, e. g. while standing or sitting.
A current connection to
the component was
interrupted Check the following points:
•
Distance from the component to the
device
• Charge level of the component's bat­
tery
• Bluetooth of the component switched
on? (Switching Bluetooth of the com­
ponent on/off)
• Hold the component with the sole of the
foot facing up to make the component
"visible" for 2 minutes.
• If multiple components were stored,
was the correct component selected?
17.2.4 Status signals
Battery charger connected
LED on
power
supply Status
LED on
battery
charger Event
Power supply and battery charger operational. Battery charger not yet
connected to receiver.