Otto Bock 17KO1 Series, Инструкция по эксплуатации

Страница: 108 / 116

INFORMATION
No status display due to battery deep discharge
If the status of the component is not displayed on the control panel, the battery may be deep discharged. In this
case it must be charged for at least 15 minutes before the status can be queried again.
Sym­
bols on
the
control
panel Beep
signal Vibra­
tion sig­
nal Event Required action
All sym­
bols on
the
control
panel
light up
alter­
nately — — Test of the indicators (LEDs) after
connecting the battery charger Check whether all symbols (LEDs) light up
alternately and in the corresponding col­
ours.
If a symbol (LED) does not light up in a
colour, the product should be inspected by
an authorised Ottobock Service Center.
If no symbols (LEDs) light up, the battery
may be deep discharged. Leave the bat­
tery charger connected for at least
15 minutes and then repeat this test by dis­
connecting/connecting the battery char­
ger.
— — The product is switched on and
ready for operation
1 x short 1 x long
and 1 x
short
The product was switched on by
pressing the
button on the control
panel.
— 1 x long
at interval
of
approx.
5 secon­
ds Overheated hydraulics Reduce activity.
— — A self-test error was detected when
connecting the battery charger.
• Conduct the self-test again by connect­
ing/disconnecting the battery charger.
• If the symbol lights up again, the
product must be inspected by an
authorised Ottobock Service Center.
For disassembly of the joint unit, see
the section “Assembling/disassembling
the joint unit on the orthosis” (see
Page 79).
30 x long 30 x long Severe error/indication of safety
mode activation (see Page 102)
Switch to safety mode if possible.
Walking possible with restrictions. Please
note the possible change in flexion/exten­
sion resistance.
1. Attempt to reset this error by switching
the product off/on (see Page 97).
2. If the beep/vibration signal recurs,
attempt to reset this error by connect­
ing/disconnecting the battery charger.
3. If the beep/vibration signal recurs, use
of the product is prohibited. The
product must be inspected by an
authorised Ottobock Service Center.
For disassembly of the joint unit, see
the section “Assembling/disassembling
the joint unit on the orthosis” (see
Page 79)
108
Appendices
C-Brace joint unit 17KO1=*