Otto Bock 17KO1 Series, Инструкция по эксплуатации

Страница: 97 / 116

Parameter Adjustment
range of the
O&P profession­
al via the adjust­
ment app Cockpit app
adjustment
range Meaning
Sitting function 0/Off - deactiv­
ated
1/On - activated Activation/deactivation of the sitting function.
This function needs to be enabled in the
adjustment app.
Volume of acoustic sig­
nal 0 to 100 0 to 100 Volume of beep signal for confirmation tones
(e.g. when switching MyModes). The "0" set­
ting deactivates the audible feedback signals.
However, warning signals are still generated
if errors occur.
Pitch of acoustic signal 1500 Hz —
3000 Hz
1500 Hz —
3000 Hz
Pitch of beep signal for confirmation tones
INFORMATION
Confirmation of the successful transfer of the parameters
A beep and vibration signal is emitted by the orthosis while changing the parameters using the Cockpit app. If the
parameter "
Volume of acoustic signal
" is set to "0", only a vibration signal is emitted.
10.4.3 Overview of adjustment parameters in MyModes
The parameters in the MyMode "
User defined
" describe the static behaviour of the orthosis for a specific move­
ment pattern such as cycling. There is no automatically controlled adjustment of the extension and flexion resist­
ance.
The parameters of the MyModes "
Training mode
" and "
Freeze position
" are preconfigured and cannot be
changed.
The following parameters can be modified in MyModes:
Parameter Adjustment app
setting range Cockpit app
adjustment
range Meaning
Flexion resistance
increase
0 to 100 +/- 10 of the con­
figured value Value for speed at which flexion resistance
increases as the knee angle increases
This parameter can only be changed in the
MyMode "
User defined
".
Volume of acoustic sig­
nal 0 to 100 0 to 100 Volume of beep signal for confirmation tones
(e.g. when switching MyModes). The "0" set­
ting deactivates the audible feedback signals.
However, warning signals are still generated
if errors occur.
Pitch of acoustic signal 1500 Hz —
3000 Hz
1500 Hz —
3000 Hz
Pitch of beep signal for confirmation tones
INFORMATION
Confirmation of the successful transfer of the parameters
A beep and vibration signal is emitted by the orthosis while changing the parameters using the Cockpit app. If the
parameter "
Volume of acoustic signal
" is set to "0", only a vibration signal is emitted.
10.5 Switching the product on/off
In certain cases, e.g. for storage or transportation, the product can be purposely switched off.
CAUTION
Using the product while switched off
Falling due to unexpected product behaviour because of changed damping behaviour.
► Prior to using the product, briefly press the button on the control panel to check whether it is switched on.
The button symbol lights up green when the product is switched on.
97 C-Brace joint unit 17KO1=*
Use