Otto Bock 17KO1 Series, Инструкция по эксплуатации

Страница: 82 / 116

Section "Connect to already saved component:"
This section shows the last two connected components. A connection to these
components can be established more quickly by tapping these serial numbers.
8.4 Changing the units for weight and length
To enter the "
Height
", "
Knee Center to floor
" and "
Weight
", the units can be changed between "
kg
" and "
lbs
"
or "
cm
" and "
ft / in
".
1) Tap the symbol in the top left corner to open the navigation menu.
2) Tap the "
App settings
" menu item.
→ The unit settings menu is displayed.
3) Tap the setting in question.
4) Tap the "
OK
" button to save the setting and close the navigation menu.
8.5 Entering patient data
After each input, a confirmation signal is emitted by the component to confirm the successful transfer of the values.
Height
Body height of the patient.
Changing the units (see Page 82).
Weight
Body weight of the patient with or without orthosis.
Changing the units (see Page 82)
Knee extension angle
Knee angle of the extension position for which the orthosis was aligned. Slight
hyperextension of the knee joint must be possible starting from this angle.
Frontal Plane angle
Input of the varus/valgus angle for the component. It has to be measured with a
goniometer.
Knee Center to floor
Distance from the knee rotation point to the floor.
Changing the units (see Page 82)
Unilateral
If the orthosis is part of a unilateral fitting, this parameter has to be selected.
Bilateral
If the orthosis is part of a bilateral fitting, this parameter has to be selected.
8.6 Calibration (zero setting)
The individual position of the joint unit has to be calibrated on the patient. If calibration on the patient is omitted,
the swing phase is initiated too early or too late due to incorrect data.
The calibration process must be repeated after every static change on the orthosis (e.g. after adjusting the ankle
joint).
82
"C-Brace Setup" adjustment app
C-Brace joint unit 17KO1=*