OTARI RADAR II, Руководство по эксплуатации

Страница: 72 / 261

3.10.2 Turning AUTO INPUT On and Off
Press the AUTO INPUT button to engage and disengage AUTO INPUT. The
LED will light indicating automatic input monitoring is enabled. This function
defaults to On when RADAR II powers up and, in most re cording circumstances,
may be left On.
3.11 AUTO PUNCH
The AUTO PUNCH function is useful when you need to punch in and out at
precisely timed location points. To get the absolute best performance of a single
word or note, for example, RADAR II can handle the punching while you can
concentrate exclusively on monitoring the performance.
Auto Punch uses the Mark In and Mark Out times as punch points, and is initiated
from the Session Controller.
3.11.1 Setting-up for an AUTO PUNCH
From the Session Controller:
1. Using the Jog Wheel, Transport or Calculator, locate to the section you
will be AUTO PUNCHing over.
2 Press the MARK IN and OUT buttons to define the beginning and end
points, respectively, of the section.
3. Arm the tracks to record upon using the Track Arm buttons. Press the
AUTO PUNCH button.
The AUTO PUNCH LED will glow solid.
4. Locate before the section using the Transport or Locate functions.
5. Hold PLAY and press Record. RADAR II will automatically enter and exit
Record when the MARK IN and OUT points are reached.
Press the AUTO PUNCH button to enable or disable this function.
3.11.2 Editing AUTO PUNCH In and Out locations
There are two ways to fine tune the AUTO PUNCH In and Out (Mark In and
Mark Out) locations. On the Session Controller, you may use the Jog Wheel to
scrub audibly to the exact location and press either of the MARK IN or OUT
buttons. You may also use the EDIT LOC function (
§X.X.X
) to directly nudge the
SMPTE times of the MARK points by frames or subframes.
Please Note: Complete procedures for scrub/shuttle operation are provided in §3.12.2.
Edition 1
3-16 S E C T I O N 3