oset 2012 12.5 24V, Общее техническое обслуживание, руководство по устранению электрических неисправностей и диагностике

Страница: 26 / 31

Symptom Component
Check Order Notes Solution
4. My OSET
won’t turn on?
No lights on
the LED
throttle display
4.1. Relay
The relay is the small black box mounted in the seat area of the
frame. It connects to the controller unit and the key switch of your
OSET and feeds in to the wiring harness. When turning the key
have a listen to the relay. In a relay that is operating correctly you
should be able to hear a noticeable ‘clicking’ noise, shortly
followed by the charge indicator lights on the throttle being
displayed. If there is an absence of this, it is likely that the relay
needs replacing. Another cause of the relay not activating would
be a faulty key switch. The two key connection wires (one from
the relay and one from the controller) can be shorted together –
creating an ‘on’ condition. If the relay now clicks, the key switch is
the problem. If it does not, it is likely the relay.
1. No Click from Relay? - Order a
New Relay – be sure to quote
the correct voltage for your
model. (It is important for this
component to specify the year
of manufacture, as the main
wires running to the vertical
and horizontal pin connector
are reversed on later models).
– **You are aiming for the Red
wire from the wire harness to
run into the red wire from the
relay**.
2. Relay Clicking? - Order a new
key switch.
4.2.
Connection
Check
If you can hear the relay actuating as detailed above, then double
check all the connections running from the battery terminals,
through the wiring harness, fuse, and key switch. Check for any
debris and evidence of arcing.
1. Replace connections if needed.
All connector blocks are available
from OSET UK
4.3 Controller
Once the above avenues of enquiry have been looked into, it may
be that your OSET has developed a fault with the control unit. In
this case there is very little you can do as it is a sealed unit. There
is a small circuit board within, and if this has been damaged in
some way or has stopped functioning then the only solution is to
change it.
1. Replace Controller, again be sure
to quote the year of manufacturer
of your OSET.
26