Orolia GSG-5 Series, Руководство пользователя с руководством по SCPI, Страница: 112 / 392

nominal frequency. With GSG-6 series simulators, it is possible to generate car-
rier signals for L1 and L2 at the same time.
Prn : Pseudo-random noise
3.6.2.2 Satellite ID
The Satellite ID field is used to specify the GPS PRN, Galileo PRN, and the GLONASS
satellite ID, therefore it is limited to 24 (the highest GLONASS satellite ID). If this field is set
to a value higher than 24, then GLONASS will not be selectable under Configure signal
types .
3.6.2.3 Transmit Power
The term Transmit Power refers to the signal power transmitted by GSG during the exe-
cution of a scenario.
The transmit power is specified in dBm .
The supported range is: Max. -65 dBm … Min. -160 dBm.
Note: External Attenuation setting decreases the Max value. For
more information, see "Adjusting Transmit Power" on
page 88"Adjusting External Attenuation" on page 90 .
Note: When the power settings of individual channels change during
scenario execution (via the > Events menu, or SCPI commands) the
power range will be further limited so that the maximum difference
between the strongest and the weakest signal is never more than
72 dB.
The resolution is: 0.1 dBm.
Default setting: -125.0 dBm
For more information on Transmit Power, see "Adjusting Transmit Power" on page 88 .
Caution: If you are using an antenna (rather than an RF cable), see "Signal
Power Level Considerations" on page 24 regarding signal level compliance
in the U.S. If you live in other countries, check your local emission standards.
96 User Manual GSG-5/6 Series Rev. 27
3.6 "Options" Menu