
17
BASIC PROGRAMMING
TO CHANGE AND STORE A REGISTRATION
When creating a new registration it is not necessary to start from scratch. It is simpler and quicker to
select and modify an existing registration. Start with a registration similar to the one which is required.
In the example that follows we will modify factory Overall Preset number 1.
1. Select Overall Preset 1 by pressing the first button on the left in the Overall Preset Section (located
directly below the DISK FEATURES Section on the right of the control panel). When the upper
keyboard is played there should now be a basic Organ sound. If this is not the case the registration
has already been altered. Reload the factory settings (See RESTORING FACTORY SOUNDS –
Page 20).
2. To change the organ sound, adjust the TABS to modify the sound to a new setting. The Sustain,
Motion Effect and Percussive effects can be selected as desired.
3. This new sound can now be stored into one of the three user organ buttons.
To store this sound:
a) Press the SET button situated below the screen (Grey Button surrounded in RED). Various lights
will start flashing.
b) Select the USER button in the Upper Flutes Section, which is flashing.
c) Select one of the organ buttons for example Organ2, which will now start flashing.
Switch off the SET button. The new organ sound is now saved in the Organ 2 button.
It will only
remain there however when saved into an Overall Preset.
Two more user organ sounds can be saved
into Organ1 and Organ3. It is therefore possible to save 3 Upper organ user presets into each Overall
Preset.
In addition, you can also alter USER sounds in the Upper Orchestra and Lower Orchestra Sections.
The following example outlines the process. To change the USER Voice for Sax in the Upper
Orchestra Section from Alto 1 to Soprano:
1. Cancel any Flute Voice by canceling the UPPER FLUTES button (below the DATA buttons).
2. Press the Sax button in the Upper Orchestra Section (turns the red LED – On). When you play a
note on the upper manual you hear a saxophone.
3. Press and Hold the grey USER button in the Upper Orchestra Section.
Red LED above the Sax button now flashes.
Display will show:
Cursor Flashing
UPPER Set Sustain 3
B__ 66
Alto 1
-