ORiNG IGS-9168GP series, Руководство пользователя

Страница: 143 / 166

IGS-9168GP User’s Manual
ORing Industrial Networking Corp 142
Master Only : master only
Slave Only : slave only
Port List Set check mark for each port configured for this Clock Instance.
2 Step Flag Static member defined by the system; true if two-step Sync
events and Pdelay_Resp events are used
Clock Identity Shows a unique clock identifier
One Way If true , one-way measurements are used. This parameter applies
only to a slave. In one-way mode no delay measurements are
performed, i.e. this is applicable only if frequency synchronization
is needed. The master always responds to delay requests.
Protocol Transport protocol used by the PTP protocol engine
Ethernet PTP over Ethernet multicast
ip4multi PTP over IPv4 multicast
ip4uni PTP over IPv4 unicast
Note: IPv4 unicast protocol only works in Master Only and Slave
Only clocks
For more information, please refer to Device Type .
In a unicast Slave Only clock, you also need to configure which
master clocks to request Announce and Sync messages from.
For more information, please refer to Unicast Slave Configuration
VLAN Tag Enable Enables VLAN tagging for PTP frames
Note: Packets are only tagged if the port is configured for vlan
tagging. i.e:
Port Type != Unaware and PortVLAN mode == None, and the port
is member of the VLAN.
VID VLAN identifiers used for tagging the PTP frames
PCP Priority code point values used for PTP frames
5.12 Troubleshooting
5.12.1 Factory Defaults
This function is to force the switch back to the original factory settings. To reset the switch,
select Reset to Factory Defaults from the drop-down list and click Yes . Only the IP
configuration is retained.