Original Saw Company 3531-01, Руководство по эксплуатации и техническому обслуживанию

Страница: 17 / 29

17 17
In Rip — Out Rip
When ripping the arm should be locked in a cross cut
position. Pull the motor to the end of the arm. Release
the yoke clamp handle by pulling forward and lift the rip
index pin. Revolve motor 90
o
right or left for out - rip or
in - rip position. Engage rip index pin and lock yoke
clamp handle. Locate saw for desired width of rip and
lock saw carriage by tightening riplock against side of
arm. Rotate guard so the in - feed side almost touches
the material. Lower anti - kickback assembly so the
fingers are approximately 1/8” lower than the material.
Place material against the guide strip and feed evenly
into the saw blade. Use push board on narrow work.
Never place hands between blade and guide fence. Do
not force material and DO NOT feed from the kickback
side of the guard. Serious injury could result. Note
Red arrows indicate direction of material
movement. Continued on next page.
!!! DANGER !!!
NEVER FEED MATERIAL FROM THE KICKBACK (Front) SIDE OF THE GUARD. SERIOUS INJURY COULD RESULT.
Operating Instructions
Rip Cutting - (rip kit required and is Optional )