Original Saw Company 3531-01, Руководство по эксплуатации и техническому обслуживанию

Страница: 18 / 29

18 18
In Rip — Out Rip
To set up guard for ripping start by swiveling the carriage into the
in rip or out rip position. Then using a wrench loosed the studs
that run through the inner guard ring retainers on both the front
and back retainers as in figure #1 and Figure #2. The rotate the
guard back or to the rear to bring the rear bottom edge of the
guard closer to the material being cut Figure 3. Using the thumb
screw adjust down the material hold down roller to contact the
surface of the material being ripped (Red arrows in Figure 4).
Then adjust down the kickback attachment on the front of the
guard so the steel fingers contacts the materiel slightly (red arrow
in Figure 3). This will keep the material from kicking back out of
the machine.
Figure 1
Figure 3
Figure 2
Operating Instructions
Rip Cutting - (rip kit required and is Optional )
Figu re 2
Figure 1
Figure 3 Figure 4