PROG
SA and SU will have same
program.
M is selected, program for M only.
M
Individual Day Programming
To program for each individual day separately by a different set of programs, first select day
by displaying the day of program, then insert the desired times and temperatures.
Press
Display Reads
PROG
DAY
M T W TH F
M to F are selected. M to F will
have same programs.
PROG
DAY
SA SU
PROG
DAY
HOUR
MIN
Use
to enter programs
for Monday.
19
The °F/°C selector switch is located on the front.
F
C
Selector Switches
°F/°C selector (Fahrenheit/Centigrade)
Your thermostat is set for °F mode from the factory. In order to change to °C mode,
slide the switch to °C.
Connect Wires & Mount Thermostat Cover to Wall Plate
Insert RJ45 Connector.
If remote temperature sensor is used: remove existing RTD Sensor from Terminals 1 & 2 and
replace with remote temperature sensor wires.
Be sure to tighten the terminal screws securely, otherwise a loose wire could cause
operational problems with your system or thermostat.
Push excess wire back into hole to prevent interference with mounting of the thermostat cover.
Customer Choice switches are accessed through terminals 3, 4 & 5. Switch #1 is accessed
through terminals 3 & 4. Switch #2 is accessed through terminals 4 & 5, with terminal #4 being
common.
Insert the bottom tab on the thermostat body into the slot at the bottom of the wallplate. Press
top of the thermostat body to snap it into the wallplate.
(NOTE: Do not force the thermostat
onto the wallplate, as the terminal pins may be damaged. If it does not snap properly,
the thermostat may not work.)
Insert the two AA size batteries, observing the polarity marked on the unit.
Installation
10
