Configuring Host Hardware Interfaces
System Operation
8-22
Ocean TRx™ 4500 Installation and Operations Manual
8.5.3
Viewing Additional Modem Parameters
NOTE:
The procedures required for integrating the modem are described in the Setup chapter. This
section describes additional information.
The OceanTRx™4-500 System can be configured to receive monitoring information from
supported satellite modems via a serial connection or via an Ethernet connection.
Installation and integration of the modem is under the customer’s responsibility. Follow
the instructions below and consult with Orbit’s Service Department for further assistance.
1. From the
Host
menu, select
Hardware Interface
... The following dialog appears:
Figure
8-20: Host Hardware Interface Satellite Modem Tab
2. Click on the
Satellite Modem
tab.
In
Type
field, Select the relevant modem type.
In
Baud Rate
field, Select the correct baud rate for the modem.
For Sky-Edge modems - enable the checkbox
Use Download Frequency for
Tracking.
Click
OK
and then click
[V]
on the keyboard and press
Enter
to save.
No other Modem Configuration Procedures are required.
