Orban OPTIMOD-FM 8600Si, Руководство по эксплуатации

Страница: 54 / 356

1-28
INTRODUCTION ORBAN MODEL 8600Si
3. Place the 8600Si in Bypass mode by remote control. Then program any
two Remote Interface inputs for “Bypass” and “Exit Test,” respectively.
A) Connect two outputs from your station remote control system to the
REMOTE INTERFACE
connector on the rear panel of the 8600Si, according to
the wiring diagram in Figure 2-2 on page 2-3.
B) Program two GPI ports for
B
YPASS and
E
XIT
T
EST according to the instructions
in Remote Control Interface Programming starting on page 2-45.
C) Place the 8600Si in bypass mode by remote control.
a) Switch the 8600Si into
BYPASS
mode by a momentary command from your
station’s remote control to the GPI port programmed as
B
YPASS .
b) Begin EAS broadcast.
c) When the EAS broadcast is finished, switch the 8600Si from
B
YPASS
mode
by a momentary command from your station’s remote control to the GPI
port programmed as
E
XIT
T
EST
.
You may also choose to insert EAS broadcast tones and data directly into the
transmitter, thus bypassing the 8600Si for the duration of the EAS tones and da-
ta broadcast.
PC Control and Security Passcode
PC software control provides access to OPTIMOD-FM via network, modem or direct
(null modem cable) connection, with IBM PC-compatible computers running Win-
dows. PC access is permitted only with a valid user-defined passcode.
PC remote control can be ended from the front panel; this feature effectively pre-
vents simultaneous remote and local control.
See Security and Passcode Programming (starting on page 2-42) for more detail.