Orban OPTIMOD-FM 5700i, Руководство по эксплуатации

Страница: 109 / 335

OPTIMOD-FM DIGITAL INSTALLATION
2-53
5. To select the analog or digital input as the audio source:
Note: When the input is set to D
IGITAL
and no valid digital signal is present at the
input, the setting of the
DI A
NALOG
F
ALLBACK
control will determine whether the
Optimod automatically switches to its analog input. See step 6 on page 2-28.
Command Response
IN X[PASSCODE]
(valid passcode and argument)
INPUT: [ANALOG, DIGITAL] (for each
output)
(invalid passcode)
[no error message is issued]
In the above table:
X = A, D
where A = analog input, D = digital input
PASSCODE = ANY VALID PASSCODE
.
•
If a non-existent control value and/or an invalid passcode is entered, the 5700i
will ignore the command.
•
You can apply this command anytime after the 5700i boots up. The 30-minute
timeout does not apply.
6. To fetch real-time operational status information from the Optimod:
This provides a real-time status report including the following information:
Command Response
RT [PASSCODE]
«
5700i Status:
digital input 1 lock [active][inactive]
digital input 2 lock [active][inactive]
remote contact closure 1 [active][inactive]
remote contact closure 2 [active][inactive]
remote contact closure 3 [active][inactive]
remote contact closure 4 [active][inactive]
remote contact closure 5 [active][inactive]
remote contact closure 6 [active][inactive]
remote contact closure 7 [active][inactive]
remote contact closure 8 [active][inactive]
tally out 1 [active][inactive]
tally out 2 [active][inactive]
7. To fetch information about the active processing preset:
Command Response
AP [PASSCODE]?
«
Returns active processing preset name