Orban OPTIMOD-FM 5700i, Руководство по эксплуатации

Страница: 102 / 335

2-46
INSTALLATION ORBAN MODEL
F) Connect your Ethernet network to the RJ45 jack on the rear panel of your
5700i.
•
If you are connecting to a hub or router, use a standard Ethernet cable.
•
If you are connecting directly to the Ethernet jack on a computer, use a “cross-
over” or “reverse” Ethernet cable.
G) Press the
Next
button.
2. Prepare the 5700i for modem connection through the serial port:
[Skip this step if you will not be using a modem connection.]
A) Navigate to
Setup > N
ETWORK
& R
EMOTE
.
B) Hold down the
PC C
ONNECT
soft button and turn the knob until you see
M
ODEM
on the display.
C) Press the M
ODEM
I
NIT
soft button.
D) If the string that appears in the display is
S0=4
, this is correct. Press the
Escape
button and skip steps (E) and (F) below.
S0=4
is the 5700i default setting. This activates auto-answer functionality
in the modem.
E) Set the I
NIT
S
TRING
to S0=4. Use the Next and Prev
KEY
s to move the cursor in
turn to each character in the modem initialization string. Use the knob to set
the character to the desired value. Repeat until you have set all the characters
in the initialization string.
F) Press the S
AVE
soft button to confirm your setting.
3. Modem setup:
You will need two modems and two available phone lines, one of each for your
PC and your 5700i. Orban Customer Service supports only the 3Com/U.S. Robot-
ics® 56kbps fax modem EXT on the 5700i side of your connection, although oth-
er 56kbps modems will often work OK.
You can use either an internal or an external modem with your PC.
A) Connect the telephone line from the wall phone jack to the wall connection
icon on the back of the modem (modem in).
B) Connect the modem to the 5700i’s serial port with a standard (not null) mo-
dem cable.
The cable provided with your 5700i is a null modem cable and will not
work.
C) Set the modem to
A
UTO
A
NSWER
and turn it on.
For 3Com/U.S. Robotics® 56kbps fax modem EXT, set dipswitches 3, 5,
and 8 in the down position to activate the
A
UTO
A
NSWER
setting. All other
dipswitches should be set to the up position.