Oracle Netra Server X3-2, Руководство по установке

Страница: 72 / 126

64 Netra Server X3-2 Installation Guide • May 2013
9. Lift each rear bracket to the desired position at the rear of the rack, and attach a
rear bracket to each of the rear rack posts.
To secure each bracket, use two of the M5 x 12.7 mm screws or two of the M6 x 13
mm screws, as you did in
Step 8 . Tighten the screws enough to secure the
brackets, but leave the brackets loose enough for adjustment later.
Note –
If your rack has 10–32 holes, use the 10–32 collar screws and 10–32 threaded
strips.
10. Align the glides attached to the server with the slide assemblies in the rack.
You might find that there is too much or too little room between the two slides
mounted in the rack, consequently the glides attached to the server might not
align correctly with the slides in the rack. If either situation occurs, loosen the
screws on the front and back brackets (
Step 8 and Step 9 ), move the brackets
inward or outward to the appropriate points, then tighten the brackets again.
11. Push in the slide buttons and slide the server all the way into the rack
enclosure.