Powering On the Acme Packet 4600 System
This section explains how to power on your Acme Packet 4600 System.
Prerequisites
The following procedure presumes that you know how to connect your Acme Packet
4600 to either AC or DC power.
Powering On the Acme Packet 4600 System
To power on the Acme Packet 4600 hardware:
1.
Plug in the appropriate AC or DC power cords for your device.
2.
Place the System Power switch in the On position. The system starts to boot.
Note:
When operating with redundant power supplies, both power supplies
must be plugged in either simultaneously or within a few seconds of
each other. If the second power supply is on long enough after the first,
an alarm is generated.
3.
The graphic display on the front control panel begins to display information when
the system boots.
Initial Log On
Once you have established the console connection, powered on the Acme Packet
4600 and a runtime image has been loaded, you are ready to login and begin
configuring the system. After the Acme Packet 4600 has initialized, the ACLI login
prompt appears in your terminal application as follows:
•
User Access Verification
•
Password:
If the Acme Packet 4600 completed booting before you connected to the console port,
press the <Enter> key on the console keyboard a few times to activate the console
connection.
Chapter 5
Powering On the Acme Packet 4600 System
5-2