4.
Using a #2 Phillips head screwdriver, tighten the screws to secure the slide rail to
the equipment rack. Do not completely torque the screws; leave a small amount of
play at this time.
5.
Expand and line up the unpainted side of the equipment rack slide rail on the
outside of the rear rack slide rail at the same height used for the front mount point.
6.
For both holes in the slide rail flange, place one #10-32 x 5/8” screw
through the flange and into the tapped hole, and screw them into place.
7.
Repeat Steps 2 and 6 for the other test equipment slide rail.
Installing Slide Rails into a Square-Hole Rack
This section explains how to mount the Acme Packet 4600 slide rail assembly into a
square-hole equipment rack. The customer can use #10-32, 1/4-20, M5 or M6 cage
nuts as an alternative, but the cage nuts will be customer-supplied along with the
associated mounting screws for the cage nut selected.
To install the slide rails on the front of a square-hole equipment rack:
Chapter 4
Cabinet-style 4-Post Chassis Installation
4-7