OPW M2010-EU, Руководство по установке

Страница: 23 / 149

2.5 Console and Peripheral Connections
2.5.1 Direct Connections
NOTE:
The SiteSentinel
®
Nano
®
console comes with a given IP address. Do not change this
address if you use a crossover cable.
To make a wired connection between the console and a PC, a standard RJ45 crossover cable is necessary.
Refer to the section
Direct Connection with a Crossover Cable
in the
M2011 SiteSentinel
®
Nano
®
Configuration Guide
for information.
2.5.2 Ethernet Connections
To make an Ethernet connection, an Ethernet cable is connected between devices at a maximum length of
91.4 m (300 feet).
TIP:
This distance can be extended through the use of hubs and routers. If more than 1.8 m (6
feet) of cable is necessary, it is recommended to use conduit for protection of the cable.
2.5.3 RS-232 Communications Conduits
If there is more than 1.8 m (6 feet) between the terminal or PC and the console, conduit must be installed to
contain the RS-232 cable.
NOTE:
The maximum length for serial communication cable is 15.2 m (50 feet).
2.6 Complete the Installation
After the console and conduits have been installed and all wiring and connections have been completed:
l
Put the console front panel cover back into position on the front of the unit. Push it in until it clicks.
l
Install the two (2) side screws that hold the front panel cover in place.
l
Go to the breaker panel and energize the console.
Doc. No.: M2010-EU Rev.: 13
Page 23 of 149