OPW M2010-EU, Руководство по установке

Страница: 134 / 149

Setting 3:
Inside the receiver, 10.000 is added to the wireless probe address, answers through the new protocol both
on RS485 and RS232.
Use this setting when two (2) receivers are installed for maximum signal coverage. The two receivers must
be connected in parallel on the RS485 line. To avoid conflicts on the transmission bus this setting should be
used on only one of the receivers.
Select and read the message from the receiver with the stronger signal. Configure the console with the probe
address or with the probe a10.000 to receive the message.
EXAMPLE:
If the wireless probe has address 03744, it is necessary to add 10.000 to query the receiver.
D) chr(13)
R) 1250=00129.37=00031.00=083+chr(10)+chr(13)
Probe address: 03744
Probe status: (0 = OK) in case of error status=1
Temperature: +25,0 °C
Product level: 129,37 mm
Water level: 31,00 mm
Setting 4:
Inside the receiver 10.000 is added to the wireless probe address, answers through the old protocol both on
RS485 and RS232.
Use this setting when two (2) receivers are installed for maximum signal coverage. The two receivers must
be connected in parallel on the RS485 line. To avoid conflicts on the transmission bus this setting should be
used on only one of the receivers.
Configure the console with the probe address or with the probe a10.000 to receive the message.
EXAMPLE:
If the wireless probe has address 03744, it is necessary to add 10.000 to query the receiver.
D) chr(13)
R) 03744=0=+250=01294=0031=237+chr(10)+chr(13)
Probe address: 03744
Probe status: (0 = OK) in case of error status=1
Temperature: +25,0 °C
Product level: 129,4 mm
Water level: 31,00 mm
Doc. No.: M2010-EU Rev.: 13
Page 134 of 149