OPW M2010-EU, Руководство по установке

Страница: 18 / 149

NOTICE: Make sure to remove the main board and put it in a static-free area before you go
to the next step. This will prevent damage to the main board components when you remove
the knockouts.
ATTENTION: Electrostatic Sensitive Device - OBEY THE PRECAUTIONS FOR
ELECTROSTATIC-DISCHARGE SENSITIVE (ESDS) DEVICES
Obey the instructions below to keep possible damage from Electrostatic-Discharge (ESD)
at a minimum.
Keep a new component to be installed in its anti-static packaging as long as possible
before you do the installation.
Hold ESDS components by the edges. Do not touch the circuitry.
6. Remove the knockouts from the bottom or top of the unit (as selected in Step 1 above). Put a small
screwdriver into the groove and hit it with force with a hammer.
TIP:
As an alternative, for a safe and clean removal of the knockouts you can use a Greenlee
hole punch, or equivalent tool if available.
7. Install the main board again and put the unit on the wall with screws the size of the screw holes or
anchors that were installed in Step 5.
8. Install the conduits in the empty knockout holes.
9. Pull the electrical wires and Tank-Probe and Smart-Sensor wires through the conduit to the console.
Doc. No.: M2010-EU Rev.: 13
Page 18 of 149