OPTIMUM
M A S C H I N E N - G E R M A N Y
Operation
Version 1.1.6 dated 2014-10-16
Page 77
Original operating instructions
F150
GB
6.8
Setting
INFORMATION
For the setup operation <JOG> (JOG operation) the sliding door for the separating
protective equipment can be opened.
In the setting mode resp. if the sliding door is open it is necessary to actuate the
acknowledgement button in order to expressively allow the movement of the
individual axes.
Refer to chapter 4 "Setup machine" of the operating instructions for "SINUMERIK 828 D".
6.8.1 Clamping workpiece and setting workpiece datum
ATTENTION!
Clamp your workpiece safely and firmly on the milling table using appropriate clamping
devices. When setting and using already created programs observe the safety clearance
in order to avoid collisions with the selected clamping means.
Use a 3D calliper or another appropriate measuring device in order determine the work-
piece zero point.
Travel the X and Y axis using the handwheel until the 3D measuring probe indicates the
value "0".
NOTE!
If you use a milling cutter to measure the workpiece datum the milling cutter radius is automati-
cally calculated. Enter it for the zero offset.
Press the button "Workpiece datum". Select the button X resp. Y axis.
Img.6-5:
Determine workpiece datum X axis resp. Y axis
