Optimum OPTimill F 150, Руководство по эксплуатации

Страница: 9 / 162

OPTIMUM
M A S C H I N E N - G E R M A N Y
Safety
Version 1.1.6 dated 2014-10-16 Page 9 Original operating instructions
F150 GB
1.3 Intended use
WARNING!
In the event of improper use, the CNC machine

will endanger personnel,

the CNC machine and other material property of the operating company will be
endangered,

the correct function of the CNC machine may be affected.
The CNC machine is designed and manufactured to be used for milling and drilling cold metals
or other non-flammable materials or materials that do not constitute a health hazard by using
commercial milling and drilling tools.
Using this machine it is possible to perform dry processing as well as processing by using cool-
ing lubricants.

"Cooling lubricants“ on page 93
The limit values of the balances of the tools need to be observed.

"Tools and tool holding
fixtures“ on page 27
The CNC machine must only be installed and operated in a dry and well-ventilated place.
The CNC machine is designed and manufactured to be used in environments where there is no
potential danger of explosion.
Intended use
If the CNC machine is used in any way other than described above, modified without the
approval of the company Optimum Maschinen Germany GmbH then the drilling-milling machine
is being used improperly.
We will not be held liable for any damages resulting from any operation which is not in accord-
ance with the intended use.
We expressly point out that the guarantee or CE conformity will expire due to any constructive
technical or procedural changes which had not been performed by the company Optimum
Maschinen Germany GmbH.
It is also part of intended use that you

observe the limits of performance of the CNC-machine,

the operating manual is observed,

the inspection and maintenance instructions are observed.
WARNING!
Severe injuries due to improper use.
It is forbidden to make any modifications or alternations to the operation values of the
CNC machine. They could endanger employees and cause damage to the CNC machine.
1.4 Reasonably foreseeable misuses
Any other use as the one determined under the "Intended use" or any use beyond the
described use shall be deemed as not in conformity and is forbidden.
Any other use has to be discussed with the manufacturer.
It is only allowed to process metal, cold and non-inflammable materials with the milling-
machine.
In order to avoid misuses it is necessary to read and understand the operating instructions
before the first commissioning.
The operators must be qualified.