Optimum 333 8160, Руководство по эксплуатации

Страница: 37 / 72

Version 1.0.4 - 2020-12-15 37 Translation of original operating manual
MH25SV EN
MH
25
SV
_GB_
5.
fm
5 Maintenance
In this chapter you will find important information about

Inspection

Maintenance

Repair
of the milling machine.
ATTENTION!
Properly performed regular maintenance is an essential prerequisite for

operational safety,

failure-free operation,

long service life of the milling machine and

the quality of the products which you manufacture.
Installations and equipment from other manufacturers must also be in good order and condition.
5.1 Safety
WARNING!
The consequences of incorrect maintenance and repair work may include:

Very serious injury to personnel working on the milling machine,

Damage to the milling machine.
Only qualified technical personnel should carry out maintenance and repair work on the
milling machine.
5.1.1 Preparation
WARNING!
Only carry out work on the milling machine if it has been disconnected from the mains
power supply.

Switching-off and securing the milling machine on page 16
Attach a warning sign.
5.1.2 Restarting
Before restarting, run a safety check.

Safety check on page 15
WARNING!
Before starting the milling machine, you must check that there is no danger for persons
and that the milling machine is not damaged.
5.2 Inspection and maintenance
The type and level of wear depends to a large extent on the individual usage and operating
conditions. Any indicated intervals therefore are only valid for the corresponding approved con-
ditions.