Operation
Version 1.0.2 - 2020-07-06
32
Translation of original instruction
DH 40CT | DH 40CTP
EN
D
H
4
0
CT_DH40CTP_G
B_4
.f
m
4.10
Spindle head
4.10.1 Swivelling the spindle head
The spindle head can be swung up to 45
° to the right or left.
Release the clamping screws on both
sides of the spindle head.
Set the desired angle using the scale.
Firmly tighten the clamping screws of
the spindle head.
ATTENTION!
The spindle head can be swung much
further. By continuing to swivel, gear
oil may seep from the ventilation hole.
Img.4-9:
Spindle head clamping screw
CAUTION!
If the screws are completely unfastened, the spindle head might fall down.
When slewing the working head, only unfasten the screws as far as necessary to be
ableto perform the settings. After having set the slewing angle, retighten the fixing
screws.
4.10.2 Turning the spindle head
The spindle head can be turned around the axis of the drilling column.
Release the clamping lever respectively the locknut on the spindle head.
Turn the spindle head to the desired position.
Retighten the clamping lever respectively the locknut on the spindle head.
Scale
Clamping bolts
