Operation
Version 1.0.2 - 2020-07-06
27
Translation of original instruction
DH 40CT | DH 40CTP
EN
D
H
4
0
CT_DH40CTP_G
B_4
.f
m
4.1.1
DH40 CTP spindle sleeve feed
Img.4-2: DH40 CTP
4.2
Safety
The drilling milling machine must only be operated under the following conditions:
The drilling milling machine is in proper working order.
The drilling milling machine is used as intended.
The operating manual is followed.
All safety devices are installed and activated.
Eliminate or have all malfunctions rectified promptly. Stop the machine immediately in the event
of any abnormality in operation and make sure it cannot be started up accidentally or without
authorisation.
Notify the person responsible immediately of any modification.
Safety during operation on page 15
4.3
Switching on the machine
ATTENTION!
Wait until the drilling milling machine has come to a complete halt before changing the
rotation direction using the rotation direction switch.
Switch on the master switch.
Close the protective device.
Select the rotation direction of the drilling milling machine using the rotation direction switch.
Two speed stages are available for each rotation direction.
The marking "R" means clockwise rotation.
Item
Designation
Item
Designation
8
Spindle sleeve switch
9
Spindle sleeve feed 0.10 | 0.18 | 0.26 mm/rev
10
Knurled screw
11
Clamping lever
12
Spindle sleeve clamping lever
8
10
11
12
9
