Operation
Version 1.0.2 - 2020-07-06
30
Translation of original instruction
DH 40CT | DH 40CTP
EN
D
H
4
0
CT_DH40CTP_G
B_4
.f
m
Check if the clamping lever of the quill is released.
Now it is possible to move the quill downward using the sleeve lever.
4.8.3
Quill clamping lever
The quill is returned to its initial position by
means of the spring force.
Use the quill clamping lever in order to fix
the quill at a determined height.
Img.4-5:
Quill clamping lever DH40 CT
4.9
Spindle sleeve feed with DH40CTP
4.9.1
Automatic sleeve feed with DH40 CTP
CAUTION!
The higher the preset number of revolutions, the greater the feed speed in the sleeve.
Make sure to use the correct speeds depending on the used material and on the drill
diameter.
Img.4-6:
Automatic sleeve feed DH40 CTP
INFORMATION
The maximum path of the drill depth stop is a full revolution of the scale ring (13).
Set the feed rate (9).
Activate the automatic spindle sleeve feed (8).
Loosen the clamping lever (12) of the sleeve.
Set the drill depth stop with scale ring (13) and the clamping lever (11).
Fine feed
Quill clamping lever
8
Automatic spindle sleeve feed selector
9
Selector switch for speed of feed
0.1 mm/rev
0.18 mm/rev
0.26 mm/rev
3
Spindle sleeve lever
11
Clamping lever scale ring
10
Knurled screw for automatic quill feed prevention
12
Spindle sleeve clamping lever
13
Scale ring drill depth
11
10
8
9
12
3
13
