Appendix
Version 1.0.2 - 2020-07-06
67
Translation of original instruction
DH 40CT | DH 40CTP
EN
D
H
4
0
CT_DH40CTP_G
B_7
.f
m
8
Appendix
8.1
Copyright
This document is protected by copyright. All derived rights are reserved, especially those of
translation, re-printing, use of figures, broadcast, reproduction by photo-mechanical or similar
means and recording in data processing systems, either partial or total.
Subject to technical changes without notice.
8.2
Terminology/Glossary
8.3
Storage
ATTENTION!
Incorrect and improper storage might result in damage or destruction of electrical and
mechanical machine components.
Store packed and unpacked parts only under the intended environmental conditions.
Follow the instructions and information on the transport box:
Term
Explanation
Drill sleeve
Fixed hollow shaft which runs in the drill spindle.
Spindle
Shaft activated by the motor
Drill chuck
Drill bit adapter can be fixed by hand.
Drill chuck
Drill bit adapter
Drill drift
Tool to release the bit or the drill chuck from the drill spindle
Taper mandrel
Cone of the drill or of the drill chuck
Tool
Drill bit, countersink, etc.
Workpiece
Part to be drilled, part to be machined.
Drilling table
Supporting surface, clamping surface
Spindle head
Upper part of the drilling- milling machine
Spindle sleeve lever
Manual operation for the drill feed
Fragile goods
(Goods require careful handling)
Protect against moisture and humid environment
Environmental conditions on page 19
Prescribed position of the packing case (Marking of
the top surface - arrows pointing to the top)
