O P T I O N A L M O D U L E I N S T A L L A T I O N
15
Step 10
: Plug the remaining end of the ribbon cable (T02) into the socket on the HDBaseT output
board. Pay attention to identify the correct direction and align the plug properly. The plug should be
locked into the socket once it is firmly plugged in.
Installing the Rack Mount Kit
The BDT-101CI can be installed into an equipment rack using the optional RMK-103 rack mount kit. The
RMK-103 kit contains three main pieces: two rack ears and one front panel filler. When it is used to rack-
mount the BDT-101CI, the front panel filler is not needed. Please follow these steps to install the rack mount
kit.
Step 1
: Remove the 4 screws from the sides of the player, 2 on each side.
Step 2
: Position one rack ear the right side of the player by aligning its top to the top of the player.
Secure the rack ear to the player using the side panel screws supplied with the rack mount kit.
Do
not use the screws removed from the player in Step 1 because those are too short.
Install the
other rack ear to the left side in the same way.
Step 3
: The completed unit should look like the figure below. It is ready to be mounted using the
screws that came with your equipment rack.
The player fits into a 2U rack space. It is recommended to leave a blank or ventilated 1U space below
and above the player to allow for better cooling. The feet of the players can be removed if there is any
obstruction that interferes with the feet.
