STAND: 17.06.2019
9910_Operation_Manual_STANDCONTROL_C1_Rev1v1_EN
Seite 8 von 41
Danger:
Children must not be allowed to play with the unit.
Danger:
Cleaning and user maintenance must not be carried out by
unsupervised children.
Caution:
You must use the supplied power supply cable! Make sure that the power
supply cable is not damaged. Operating the STAND.CONTROL C1 with a damaged
electrical cord is prohibited.
Danger:
Before connecting and disconnecting drives, manual switches, or other
accessories to the motor control unit, be sure to disconnect the power cable from
the mains without fail.
Caution:
Only use original accessories from Oelschläger
Metalltechnik
GmbH.
The use of components and parts from third parties is prohibited! If unsuitable
accessories are used, damage or destruction of the table frame or the electronic
components can occur.
Warning:
If there is a malfunction (for example, unwanted movement of the table
top if, for example, a button of the hand switch gets stuck), please immediately
unplug the power cord.
Danger:
Protect all electrical components on the table frame from moisture and
dripping or splashing water.
Danger:
There is a danger of being crushed when the desktop position is changed!
Therefore, make sure there are no objects or persons present in the danger zone
and do not reach into the danger zone.
Danger:
Modifications to the table controller are prohibited.
Danger:
The STAND.CONTROL C1 must not be operated in explosive atmospheres.
Danger:
If a malfunction occurs, the desktop might move slightly with every start,
before the safety shutoff comes into action. Pay attention to a possible danger of
crushing.
Danger:
The collision protection described is not active during any reset process
(see Section 8.4).
Danger:
If the product is visibly damaged, it may neither be assembled nor used.
Note:
When unpacking, ensure ESD-compliant handling of the electronic components.
