STAND: 17.06.2019
9910_Operation_Manual_STANDCONTROL_C1_Rev1v1_EN
Seite 14 von 41
7 Installation
7.1 Unpacking
Note:
When unpacking, ensure ESD-compliant handling of the electronic components.
Caution:
Oelschläger
Metalltechnik
GmbH does not provide any warranty for faults
and damage to the device that are the result of electrostatic discharge.
For unpacking electronic devices, please proceed as follows:
1. Remove the packaging material.
2. Check the contents of the package for completeness.
3. Dispose of the packaging material in an environment-friendly manner, in accordance with the
applicable national regulations in your country. Recycle reusable packaging.
7.2 Installation
Assemble the table controller STAND.CONTROL C1 on the underside of your table. The table control-
ler is normally fitted with screws below the desktop.
Alternatively, it is possible to install the controller with a controller holder if the table-top support frame
is already pre-fitted for it, for example, FREE.STAND 9051 (see: 7.2.2).
7.2.1 Assembly with tools
You need the following materials and tools for the assembly:
- Pencil
- Drilling machine
- 2 screws
- Screwdrivers of a size suitable for the screws
Note:
Before assembly, the controller must be electrically de-energised.
Note:
The screws are not included in the scope of delivery since they have to be
selected depending on the material and the thickness of the desktop.
Ø 6.3 mm holes are provided on the controller for this purpose. Use fillister-head or
cheese-head screws.
The tightening torque depends on the desktop material, but should not exceed 2 Nm.
For assembly, keep the following steps in mind:
1. Position the table controller at the desired place. Ensure that the leg space of the user is not
restricted.
2. Mark the bore holes with a pencil.
