STAND: 17.06.2019
9910_Operation_Manual_STANDCONTROL_C1_Rev1v1_EN
Seite 28 von 41
In the absence of any selection or further actions, after approx. 6 seconds, the display automatically
switches back to the main menu.
10.1.8 Delete shelf and container stop (depending on the configuration)
Warning:
Only trained personnel should delete container and shelf stops.
There is a danger of injury from removal of the Stop positions, and a danger
of the table getting destroyed.
Note:
This menu option is not present in all controller configurations. If the menu option
is not present, the user is not permitted to delete a container stop or a shelf stop.
Note:
With the additional stops, the safety of the table system can be increased,
in that the possible movement path is restricted.
To delete a container stop or a shelf stop, proceed as follows:
1. Go to the menu of the hand switch in accordance with the instructions.
2. If necessary, using the arrow keys ( and ) navigate to menu option 5. The display must
show
.
3. Confirm the selection by once again pressing the “Logo” key.
4. Now select:
a. Press , to delete the shelf stop (upper stop).
b. Press , to delete the container stop (lower stop).
5. Confirm the input by once again pressing the “Logo” key. Alternatively, wait for approx.
6 seconds.
6. You are once again in the main menu and can make further settings.
The setting is permanently saved in the controller and is retained even when the hand switch is
replaced.
In the absence of any selection or further actions, after approx. 6 seconds, the display automatically
switches back to the main menu.
10.1.9 Automatic movement
Warning:
The automatic movement function is fundamentally disabled upon delivery.
Activating the automatic movement invalidates the evaluation of the controller
according to EN ISO 13849-1 PL b Category B.
If the controller is being used within the scope of this standard, you must carry out
a new evaluation in accordance with the specifications of EN 60335-1 and EN
ISO 13849. Generally, according to the specifications of the standard, automatic
movement is not permitted.
Oelschläger
Metalltechnik
GmbH does not accept liability for injuries or damage
that could result from the use of the automatic movement.
Warning:
Automatic movement of the table brings a greater danger of injury with it.
Pay particular attention to the table and its surroundings while the desktop is moving.
