Omron V750 series, Руководство по подключению к сети

Страница: 8 / 78

4. Overview
4. Overview
This document describes the procedure for connecting the RFID Reader/Writer (V750 series)
of OMRON Corporation (hereinafter referred to as OMRON) to the NJ-series Machine
Automation Controller (hereinafter referred to as Controller) through Ethernet, and provides
the procedure for checking their connection.
Refer to the Ethernet communications settings of the prepared project file to understand the
setting procedure and key points to connect the devices via Ethernet.
The user program in this project file is used to check the Ethernet connection by
sending/receiving the message of “GETR TYP FWV (read the product type and firmware
version of the memory data)” to/from the destination device.
Prepare the latest Sysmac Studio project file beforehand. For information on how to obtain the
file, contact your OMRON representative.
Name File name Version
Sysmac Studio project file
(extension: smc) OMRON_V750_ETN(TCP)_EV101.smc Ver.1.01
*Hereinafter, the Sysmac Studio project file is referred to as the “project file”.
The user program in the project file is referred to as the “program”.
This document aims to explain the wiring method and communications settings
necessary to connect the corresponding devices and provide the setting
procedure. The program used in this document is designed to check if the
connection was properly established, and is not designed to be constantly used
at a site. Therefore, functionality and performances are not sufficiently taken into
consideration. When you construct an actual system, please use the wiring
method, communications settings and setting procedure described in this
document as a reference and design a new program according to your
application needs.
5